Search Results for: shot blasting

Introduction Bonding agents are products that help new concrete stick to old surfaces. They improve adhesion when the surface is clean, sound, and properly prepared. If you skip cleaning or misapply them, they can weaken the repair. Before choosing a method, decide whether you should repair or replace based on damage and load. Focus on

Introduction Concrete form release is a coating applied to forms to prevent sticking and to help control staining and color issues on the surface. Key takeaways Choose release agents carefully; improper use can stain and dull decorative color. Plan form removal timing with manufacturer instructions and local code guidance. Use recommended tools and materials from

Introduction Concrete moisture problems indoors occur when water moves through or sits in the slab, which can undermine coatings and sealers. This movement changes how the surface behaves and can cause failure even after installation. Start by understanding where the moisture is coming from and how the slab dries over time. First, visually inspect for

Introduction CSP, or Concrete Surface Profile, is the roughness pattern of a freshly poured concrete surface that helps coatings grab hold. It describes how the top layer is prepared to receive a finish. You’ll influence it by how you treat the surface during finishing and, if needed, with light grinding or etching to adjust texture.

Introduction Peeling is when a previously applied stain sealer lifts, flakes, or dulls away from the concrete surface. This usually happens when the sealer didn’t bond well, or when the surface wasn’t prepared or conditioned properly. In DIY terms, you’ll often see peeling after weathering, moisture, or mismatched coatings. To recoat correctly, start with a

Introduction Removing a failed acrylic sealer from concrete without etching means lifting the film without harming the concrete surface. Do this safely with good ventilation, eye protection, and gloves, and follow the product instructions. Your choice of remover depends on the sealer type and the concrete porosity, so always check the label and local rules