Matt L.

Introduction Carbonation depth mapping across a slab is the practice of measuring how far carbonation has penetrated the concrete across different spots. This helps you see where the concrete is more or less exposed to carbonation, not just at one point. In plain terms, you’re looking for variations rather than a single number. Why one […]

Introduction Measuring concrete cover accurately means checking how far the rebar or embedded metal sits from the surface, instead of guessing and hoping it’s close enough. In practice, small errors in this measurement can lead to long-term problems like spalling or cracking under load and weather. For DIY work, treat cover as a real detail

Introduction ASR is a chemical reaction in concrete between alkalis and reactive silica in aggregates that can lead to slow expansion and cracking. In the field, it can look like cracking, blistering, or powdery patches that mimic other problems. Understanding these symptoms helps you tell whether you might be dealing with ASR or something else.

Introduction Salt scaling risk on exterior slabs is the tendency for surface flaking and crumbling when moisture is drawn into the top layer and then freezes. This simple field check helps you spot potential damage before winter hits. If you see rough patches or powdery material forming, that can signal trouble. Signs to watch in

Introduction Honeycombing in formed walls is a condition where voids and rough cement gaps appear on the surface, signaling poor compaction and near-surface voids. For DIY homeowners, identify it by a spongy or crumbling feel, visible voids, and a rough, uneven finish. Addressing it depends on how widespread it is and whether the inner steel

Introduction Concrete surface contamination tests tell you whether a surface is clean enough for bonding by revealing any residual oils, silicones, or waxes. For epoxy or other adhesives, you must verify cleanliness requirements with the product label and local rules, because expectations vary. If unsure, follow a basic check: a dry, dust-free feel and a

Introduction Dye penetrant testing is a simple non-destructive method to reveal hairline cracks in concrete that you can’t see with the naked eye. This article explains what it is, how it works at a DIY level, and what you can safely check yourself. You’ll get a plain, hands-on look at when to consider this method

Introduction Hammer sounding and chain drag are practical field tests to locate delaminations and hollow areas in concrete. You tap or drag along the surface and listen for changes in tone and feel. These methods help you decide where to drill, patch, or reinforce without guesswork. Hammer sounding uses a light tapping with a hammer

Introduction Crack monitoring on slabs is watching cracks for changes to tell if the slab is moving. You use simple tell-tales or gauges to notice width changes over time, so you can decide if action is needed. Keep it plain and repeatable, with measurements at the same spots. Start with an initial measurement of the

Introduction RH probes map moisture in concrete by measuring relative humidity within the slab and comparing it to a calibrated standard. They assess moisture deeper in the concrete rather than just the surface, giving a more complete picture for decisions on finishing or coatings. This article will compare that approach with handheld meters in plain,