Informative

Informative is where I post general notes and observations from working with concrete and cement-based materials.

These aren’t always step-by-step tutorials. They’re more like field notes: what’s changing in materials, what works in practice, and how to think about common problems before they happen.

If you like the “why” behind the how-to guides, you’ll probably enjoy this section.

Hand with glove inserting tool into brown plastic fastener on foam board

Epoxy anchor guns: cartridge care, purge steps, and nozzle reuse reality

Tools & Equipment /

Introduction Epoxy anchor guns rely on careful cartridge care, proper purge steps, and mindful nozzle reuse to stay reliable. Keeping cartridges clean, stored, and upright helps prevent jams and inconsistent mixing. Purge steps before use remove air and unmixed material, reducing the risk of cured epoxy affecting the next shot. Nozzle reuse requires attention to […]

Epoxy anchor guns: cartridge care, purge steps, and nozzle reuse reality Read More »

Hand using yellow electric drill to drill hole in masonry wall

Masonry anchors compared: sleeve, wedge, tapcon, and epoxy

Brick & Block /

Introduction Masonry anchors secure items to brick or concrete by gripping into the material. This guide compares sleeve, wedge, tapcon, and epoxy anchors, focusing on their grip mechanisms, installation methods, and ideal applications. Each anchor type has a unique setup and installation approach: Sleeve and Wedge Anchors: These use expansion grip to secure into place.

Masonry anchors compared: sleeve, wedge, tapcon, and epoxy Read More »

Hand holding drill against concrete wall surface

Drilling into masonry: SDS settings, bit types, and how to stop wandering

Brick & Block /

Introduction Drilling into masonry means using a hammer drill with an appropriate SDS bit to bore into brick, concrete, or stone. This article gives a practical overview of choosing settings, bit types, and how to keep the drill from wandering. It sticks to plain language and hands‑on tips for real work on the job site.

Drilling into masonry: SDS settings, bit types, and how to stop wandering Read More »